Philips 15V1320 Uživatelský manuál stáhnout pdf

Introduction

The PHILIPS 105S colour monitor displays sharp and brilliant images

of text and graphics with a maximum resolution up to 1024x768 pixels.

It is optimal for Windows, spread sheets, and any other application.

This monitor automatically scans horizontal frequencies from 30KHz to

54KHz, and vertical frequencies from 50Hz to 110Hz. With

microprocessor based digital controlled circuit, the monitor can

automatically adjust itself to the video card’s scanning frequency and

displays an image with precise parameters you desire. The wide range

of scanning frequency supports variety of operating platforms, such as

IBM PC and compatibles, including Intel based platforms such as 386,

486, Pentium and Pentium Pro.

Feature Highlights

• New Styling demonstrates a smart image.

• Digital Control feature provides user-friendliness and ease-of-use

when operating the monitor.

• Anti-Glare and Anti-Static screen coating eliminate any bad effects

caused by the screen surface such as reflection of the room lights

and dust attraction.

• 85Hz refresh rate:

The maximum display resolution is 1024 x 768 pixels non-interlaced

mode. The recommanded optimum resolution up to 800 x 600 pixels

non-interlaced by maximum 85Hz refresh rate.

• Green Design including automatic power saving function (NUTEK)

and low emission MPRII compliance shows our commitment in

environmental care.

• DDC1/DDC2B allows communication between the monitor and PC

system for optimal video configuration.

1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - Feature Highlights

1ENIntroductionThe PHILIPS 105S colour monitor displays sharp and brilliant imagesof text and graphics with a maximum resolution up to 1024x768 pixels

Strany 2

10EN(B) Power Management SignallingPower Management Definition VESA DPMS POWER SAVING STATESMODE VIDEO H-SYNC V-SYNC POWE

Strany 3 - End of life disposal

11ENTechnical information(I) General:Picture tube : 15 inch (38.1 cm), 90° deflection, non-glare, black matrix,light transmission57%, phosphor P22 me

Strany 4 - Installation

12EN(III) Pin assignment:(1) The 15-pin D-sub connector (male) of the signal cable (IBM systems):1 Red video input 9 No pin2 Green video input 10 Logi

Strany 5 - Connection

13ENEnglish Operating instructions 1 ... 12Deutsch Bedienungsanleitung 13 ... 24Français Mode d’emploi 25 ... 36Digit

Strany 6 - Connection to the mains

2ENNote: If you experienced your monitor display is changing from color tomono, it's possible that you are using a non-VESA-DDC-standard videocar

Strany 7

3ENSafety precautions and maintenance◆ Disconnect the monitor from the mains supply if the monitor is not tobe used for an extended period of time.◆ D

Strany 8

4ENInstallationImportant: Please refer to the user’s manuals of your computerand video adapter to make sure these equipments are properlyinstalled and

Strany 9 - Adjustment

5ENConnectionIntel Based platform: 386, 486, Pentium, or other compatibles:• Connect the monitor to the computer using the supplied interfacecables.Im

Strany 10

6ENConnection to the mains(Rear of the monitor)Connecting to the mainsThis monitor is set to operate at a mains supply of 100-240 volts AC(15C1320W);

Strany 11 - Technical information

7ENFront Control locations and functionsFor an optimized adjustment of the picture following controls areavailable at the front.POWER.Press this knob,

Strany 12

8ENThe function pads:H-Shift : to adjust the horizontal position of the image.H-Size : to adjust the horizontal amplitude of the image.V-Shift :

Strany 13 - 25 ..... 36

9EN(A) User mode: (15 modes) The set will save the user's setting parameters automatically. After 10 seconds of key-pad inactivity, the LED wil