Philips MZ1100 Uživatelský manuál stáhnout pdf (Strana 23)

English

3139 115 21652

WARNING

Under no circumstances should you try to repair the system yourself, as this will

invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you

are unable to solve a problem by following these hints, consult your dealer or service center.

Troubleshooting

The disc is ejected automatically.

Radio reception is poor.

The system does not react when buttons are

pressed.

Sound cannot be heard or is of poor quality.

The left and right sound outputs are reversed.

The remote control does not function

properly.

The timer is not working.

✔ Load in the disc with label facing right.

✔ Replace or clean the disc, see “Maintenance”.

✔ Use a finalized CD-RW or a correct MP3-CD format

disc.

✔ If the signal is too weak, adjust the antenna or connect

an external antenna for better reception.

✔ Increase the distance between the system and your TV

or VCR.

✔ Remove and reconnect the AC power plug and switch

on the system again.

✔ Adjust the volume.

✔ Disconnect the headphones.

✔ Check that the speakers are connected correctly.

✔ Make sure the MP3-CD was recorded within 32-256

kbps bit rate with sampling frequencies at 48 kHz,

44.1 kHz or 32 kHz.

✔ Check the speaker connections and location.

✔ Select the source (MP3-CD or TUNER, for example)

before pressing the function button (ÉÅ, S,

T).

✔ Reduce the distance between the remote control and

the system.

✔ Replace the battery.

✔ Point the remote control directly toward the IR sensor.

✔ Set the clock correctly.

✔ Press and hold CLK/TIMER to switch on the timer.

Problem

Solution

1 2 ... 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Philips MZ1100 Uživatelský manuál Strana 23

Komentáře k této Příručce

Související produkty a manuály pro Rádio Philips MZ1100